Giant Red Poured in Place Repair Kit

Availability: In Stock!
$420.00

Wear Layer Poured-in-Place Rubber

-40 lbs of EPDM Rubber Granules

-8.39 lbs of Aromatic Binder

Compare

When a standard 10-pound patch kit is not enough for your Poured Rubber Repair job but ordering bulk quantities of rubber is excessive, this Giant Patch Kit is a perfect solution.

Weighing in at just under 50 pounds (40lbs of rubber / 8.39lbs of glue) this kit will fill 20 square feet of space at a depth of 0.5 inches.

Instructions:

You will need: A utility knife, a wheelbarrow for mixing, a plastic contractor bag, a shovel, a rounded trowel, soapy water and gloves

  1. Make sure you pick a dry day to patch you rubber playground surface.
  2. Using a sharp utility knife, create a clean cut around the areas you would like to patch. When cutting, make sure to cut the edges of the area at a 45-degree angle. This will create a stronger bond at the edges of the patch.
  3. Clean the area of all loose granules and debris.
  4. Lay the contractor bag inside the wheelbarrow and tape the edges to the rim.
  5. Pour all of the rubber granules into the wheelbarrow and mix with the entire content of the binder.
  6. Mix the content thoroughly. Make sure that all the rubber granules are coated evenly with the binder.
  7. Using a rounded trowel spread the mix onto the area you are patching.
  8. Use a mixture of water and liquid hand soap to lubricate the trowel after each pass.
  9. Secure the area and let cure for 24 to 48 hours.

Click here for a downloadable instruction sheet

Contact Us

Sales and Mailing Address:
Trassig Corp.
65 Redding Rd. Unit 874
Georgetown, CT 06829

Warehouse:
Trassig Corp.
23 Henry St.
Bethel, CT 06801

Phone: 203-659-0456
Fax: 203.549.0409
E-Mail: info@trassig.com